Rail King SD-90 MAC Manual do Operador descarregar pdf (Página 3)

Set Up

There are a couple of simple steps you must take before operating this Premier

diesel.

1. Although the engine was lubricated at the factory, it is important that you

lubricate the chassis before operation. Lightly grease the outside idler and drive

gears (marked “G” in Fig. 7 on pg. 13) with lithium-based grease to prevent

them from squeaking and premature wear. Use light household oil and follow

the lubrication points (marked “L” in Fig. 5 on pg. 12). Do not over-oil. Use

only a drop or two on each pivot point.

2. Prime the operating smoke unit with smoke fluid before operating. Add 15-

20 drops of smoke fluid through the smokestack (see Fig. 2 on pg. 10), then

gently blow into the stack to eliminate any air bubbles in the fluid.

3. If you choose not to prime the unit with fluid, turn the smoke unit switch

located under the engine to the OFF position (see Fig. 3 on pg. 10). Running the

engine without a primed smoke unit may cause damage. See the “ProtoSmoke

Unit Operation” section of this book for more information on smoke unit

maintenance.

At this point, you are ready to put your engine on the track and begin running it.

Premier Scale SD90MAC Diesel Engine Operating Instructions

1 2 3 4 5 6 7 8 ... 26 27

Sem comentários

Rail King SD-90 MAC Manual do Operador Página 3